--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/mcabber/doc/help/en/hlp_msay.txt	Wed Jun 21 20:55:28 2006 +0200
@@ -0,0 +1,21 @@
+
+ /MSAY begin|verbatim|send|send_to|toggle|abort
+
+Send a multi-line message.  To write a single message with several lines, the 'multi-line mode' should be used.
+In multi-line mode, each line (except command lines) typed in the input line will be added to the multi-line message.  Once the message is finished, it can be sent to the current selected buddy with the "/msay send" command.
+The 'begin' subcommand enables multi-line mode.  Note that it allows a message subject to be specified.
+The 'verbatim' multi-line mode disables commands, so that it is possible to enter lines starting with a slash.  Only the "/msay" command (with send or abort parameters) can be used to exit verbatim mode.
+The 'toggle' subcommand can be bound to a key to use the multi-line mode quickly (for example, "bind M13 = msay toggle" to switch using the Meta-Enter combination).
+
+/msay begin [subject]
+ Enter multi-line mode
+/msay verbatim
+ Enter verbatim multi-line mode
+/msay send
+ Send the current multi-line message to the currently selected buddy
+/msay send_to [jid]
+ Send the current multi-line message to [jid]
+/msay toggle
+ Switch to/from multi-line mode (begin/send)
+/msay abort
+ Leave multi-line mode without sending the message